Dynalink ADSL2+ Wireless VoIP Router RTA1046VW Uživatelský manuál Strana 2

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 3
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 1
All-in-one Integrated Access Device
Technical Specifications (RTA1046VW)
Voice Transport: compliance to RTP (RFC1889)
Voice Codec: G.711 (a-law and u-law),
G.726 and G.729
Tone/Ring Signal: compliance to Australia & New
Zealand standards.
Tone Detection: support DTMF
Echo Cancellation: G.168 compliance
Support FAX/Analog Modem function via
PSTN port
Support RFC2833 RTP Payload for DTMF Digits,
Telephony Tones and Telephony Signals
Two VoIP (FXS) ports for VoIP phone calls
supporting intelligent lifeline backup when there
is no Internet service.
Manual selection of PSTN mode or VoIP mode for
making phone calls
Automatic selection of PSTN when an emergency
number is dialled.
Routing
NAT / PAT allows multiple users to share
Internet access
UPnP IGD with NAT traversal capability
Port Forwarding: users can setup multiple virtual
servers (e.g., Web, FTP, Mail servers) on the
local network.
Static routing & dynamic routing RIPv1/v2
DNS Relay, Dynamic DNS
DHCP Client/Relay/Server
IGMP Proxy
Support IP/Bridge QoS for different traffic classes
Support 802.1Q VLAN Tagging
Configuration and Management
Embedded web configuration interface with
password protection
Remote management control
Telnet session for local or remote management
System events logging
DSL connection diagnostics
Firmware upgrade via web browser
User setting backup & restore
SNMPv1/v2 agent with MIB-II, ADSL Line MIB
ADSL Compliance
ADSL
ANSI T1.413 Issue 2
ITU G.992.1 Annex A (G.dmt)
ITU G.992.2 Annex A (G.lite)
ITU G.994.1 (G.hs)
Support dying gasp
Maximum Rate: 8 Mbps downstream and
1 Mbps upstream
ADSL2
ITU G.992.3 Annex A (G.dmt)
ITU G.992.4 Annex A (G.lite)
Maximum Rate: 12 Mbps downstream and
1 Mbps upstream
ADSL2+
ITU G.992.5 Annex A (G.dmt)
Maximum Rate: 24 Mbps downstream and
1.2 Mbps upstream
ATM
PPPoA (RFC 2364) and PPPoA Bridged mode
PPPoE (RFC 2516) and PPPoE Bridged mode
IPoA (RFC 2225)
Bridged mode over AAL5 (RFC2684/1483)
ATM Forum UNI 3.1 / 4.0 compliant PVCs
UBR and CBR with traffic shaping
OAM F4/F5 loopback cells
Bridging
IEEE 802.1d self-learning bridge
Learning up to 4096 MAC addresses
Transparent Bridging between 10/100 Mb
Ethernet and USB
Supports IGMP Snooping
Supports 802.1Q VLAN packet pass-through
Voice over IP Features
Call Feature: basic outgoing and incoming
call, Call Waiting, Three Party Conference, Call
Transfer, Caller ID (only when supported by
service provider).
Call Control: SIP (RFC3261)
www.dynalink.co.nz www.dynalink.com.au
Zobrazit stránku 1
1 2 3

Komentáře k této Příručce

Žádné komentáře