Dynalink ADSL2+ Wireless VoIP Router RTA1046VW Uživatelský manuál stáhnout pdf (Strana 103)

Chapter 4: Web Configuration

Example – Static Route

Here provides you an example of Static Route.

For the LAN shown above, if the PC in the subnet of 192.168.1.x wants to access

the PC in the subnet of 192.168.10.x, we can set a static route in the device, in

which the destination is the PC in the subnet 192.168.10.x and the gateway is router

B. The setting would be as follows:

Destination: 192.168.10.0

Netmask: 255.255.255.0 (Standard Class C)

Gateway: 192.168.1.254 (Router B)

IP Routing – Dynamic Routing

Routing Information Protocol (RIP) is utilized by means of exchanging routing

information between routers. It helps the routers to determine optimal routes. This

page allows you to enable/disable this function.

RIP Version:

It incorporates the RIP information

when receiving and broadcasting the

RIP packets. From the drop down

menu, select a RIP version to be

accepted, 1, 2 or both.

Operation:

There are two modes for you to

choose, Active and Passive. Select

Active for transmitting and receiving

data, or select Passive for receiving

data only.

Enabled:

Check Enabled to enable the RIP

function on different interface.

Otherwise, disable this function.

Click Apply to invoke the settings set

here.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 171 172

Žádné komentáře

Dynalink ADSL2+ Wireless VoIP Router RTA1046VW Uživatelský manuál Strana 103